Browse Categories

X10 Water / Moisture Sensor

<< Previous in Security Sensors Next in Security Sensors >>
X10 Water/Moisture Sensor

Product Reviews

Rate This Product:
or Create a Review
(2 Ratings, 1 Review) Average Rating:
ratingratingratingratingrating
ratingratingratingratingrating
X10 Water Sensor
Phil (Scranton, NJ) 7/6/2011 10:57 AM
Hooks to a Powerflash or similar. Easy install. I had it working in just a few minutes. Worth the peace of mind. I have a spot in the basement I intend to add one to as well. Good product and no issues. I had older type with batteries and no X10 interface before and I won't use those again.
List Price: $55.99
Price: $39.55
You Save: $16.44 (29 %)

Item Number: 71932
Manufacturer: Minotaur Engineering

Catch leaks as soon as they start with a water-sensor system that triggers X10-connected lamps to flash. The X10 Water/Moisture Sensor can detect moisture on any non-conductive surface and send a signal to any X10 receiver in range via an X10 Powerflash module (sold separately).

The X10 Water/Moisture Sensor connects to the Powerflash module via two leads on a 5-foot cable. Place the sensor so that the two probes touch the surface to be protected using the included self-adhesive wire tie and holder to position the sensor in your desired location.

When the X10 Water/Moisture Sensor detects moisture on the surface it's monitoring, the Powerflash module will set one of three events in motion, as determined by the user:

  • All lamp modules (sold separately) set to the same house code as the Powerflash will turn on, and all appliance modules (sold separately) set to the same house and unit code as the Powerflash will turn on. Appliance modules will turn off when the moisture is removed, lamp modules will stay on.
  • All lamp modules set to the same house code as the Powerflash will flash. All will remain on when moisture is removed.
  • All lamp and appliance modules set to the same house and unit code as the interface will turn on. All will turn off when moisture is removed.